The Honda PCX / Forza / ADV150 / SH Forums

I have a pcx150 !!! I keep braking belts : any ideas on how to fix that problem?
Have malossi vareator with ncy drive face!

Gonna need more info than that. What belt, miles on the bike, mileage between belt breakage, etc.
With what you put up so far, I recommend putting the stock parts in and calling it well enough.

troy wrote:I have a pcx150 !!! I keep braking belts : any ideas on how to fix that problem?
Have malossi vareator with ncy drive face!

What belts are you using?
All aftermarket ones are of inferior quality to the standard one.
The guaranteed cure to the problem is to refit all the standard parts.

It's probably an incompatible mixture of parts or the incorrect parts for the bike.
There are plenty of theads on here as to what works and what doesn't.

Alibally wrote:It's probably an incompatible mixture of parts or the incorrect parts for the bike.
There are plenty of theads on here as to what works and what doesn't.

Something works?

you you wrote:

Alibally wrote:It's probably an incompatible mixture of parts or the incorrect parts for the bike.
There are plenty of theads on here as to what works and what doesn't.

Something works?

Allegedly

Your mix n match pulleys are probably causing out of alignment. Run it on the stand with the cover off to see if the belt looks crooked.

If using a Malossi belt, they are wider so get pushed further out. With NYC 120mm pulley half you may be rubbing the belt on the casing?

If the belt is pushed out too far, it will also be hanging half off the pully. Run it on the stand with the cover off to see.