Page 1 of 1
Forza wheel trim strips
Posted: Sat Oct 18, 2014 5:23 pm
by fish
Used a sheet of '12" - 15" ' pre-curved, pre-cut strips and the "wet" install method.
I like the looks of them, but they are not relfective.
Seems the reflective curved strips to fit small scooter wheels are not available here in the States, and must be purchased from China or Korea.
The small car jack and a block of pine worked fine on the lift point. The front tire comes off the ground in just a turn or two of the jack.
Re: Forza wheel trim strips
Posted: Wed Oct 22, 2014 10:36 am
by JoshM
Super cheap mod, but looks so nice when complete!
Re: Forza wheel trim strips
Posted: Mon Oct 27, 2014 7:36 pm
by fish
Put on these
reflective rim tapes today.....
Re: Forza wheel trim strips
Posted: Mon Nov 10, 2014 9:13 am
by drol343
fish
Your wheel trim looks great!
Question... when you raised the front tire with the car jack and block of wood, was the Forza on its Center Stand? I don't want to assume something and drop the scooter! Thanks.
Re: Forza wheel trim strips
Posted: Mon Nov 10, 2014 9:19 am
by SECoda
Looks good and those actual reflectors will do the trick handily.
Re: Forza wheel trim strips
Posted: Mon Nov 10, 2014 10:55 am
by fish
drol343 wrote:fish
Your wheel trim looks great!
Question... when you raised the front tire with the car jack and block of wood, was the Forza on its Center Stand? I don't want to assume something and drop the scooter! Thanks.
Yes, I had it on the.center stand....you only need to turn the.jack a very little to get the tire free of the ground.
Be certain to set the jack and board under that lift point visible under the scooter. I have photos posted of it.
Fish