The Honda PCX / Forza / ADV150 / SH Forums

The new 2025 model I purchased looks very nice as they have covered all wires with a plastic cover in the handle bar. But this has opened up a new problem - there is no handle bar exposed to install a phone mount. Please please - if anyone knows of any contraption that would circumvent this issue......

iyernat wrote: ↑Sun Jun 08, 2025 12:05 pm The new 2025 model I purchased looks very nice as they have covered all wires with a plastic cover in the handle bar. But this has opened up a new problem - there is no handle bar exposed to install a phone mount. Please please - if anyone knows of any contraption that would circumvent this issue......

The 2025 PCX is my 1st scooter. I'm pleased with the it. I'm on the fence deciding if the 'pearl gray' is more appealing than last years matte brown.
I have heated grips in hand and I'm trying to decide where to mount the controller. I considered grips with the controller built into the grips but opted for a less expensive pair like I've used on the last 3 bikes. I may regret the cost savings if the extra effort is more than I expected.
I'm old, feeble, and easily confused, so any additional electronics or mounts to look at would only distract me. I need to keep things simple.
I have a service manual on order. I'm hoping for easy removal/install for the cover over the handlebar.

Personally, I think those plastics on the bars looks hideous. Then again I think the stock bars on all PCX are ugly (hence me changing out my bars to Z-bars.

I would suggest just removing the plastic covers and exposing the bars to use a traditional Bar Mount. Or you can notch the plastics.