How-To: Delete Your Fender Like a Pro
Posted: Thu Jun 19, 2014 9:29 pm
That's right no more paying over priced delete kits for your fender. Here's my how-to came up with it in my head on the way home from work.
Tools Need
Vibrating oscillating saw (harbor freight version is killer with half moon metal wood blade)
File for smoothing out the plastic
Ummmm Beer????
Stock factory whale tail
Now lets get started
use the factory line that was created from the mold when they made the fender
Here you can faintly see the factory line
The plastic slag left behind from the saw, no get your file out
Purdy
Done!!! This is the version 1 creation... Just wait it gets more intense!
Now for version 2 not for the noobie! So pay attention and take your time!
First removing the factory plate mount
Now it's time to remove the section of the fendor where the lisense plate light goes. Pull on the wires behind this peice as the light is held in with a rubber socket
Again use the factory mold line to get everything dialed in perfectly
Finally removed the lower section
TAKE YOUR TIME NOW IF YOU FFFFFFFFFFF UP IT IS ON YOU!!! <---DISCLAIMER!!!
NOW SLOWLY Take little pieces out enabling you to open up this area of the fender. You can use the lines where the curves meet each other.
Getting closer to flushing this section out
TADA!!! We have a winner!!! No paying 100+ bucks for a fender delete kit
Hope you guys enjoy this!
Tools Need
Vibrating oscillating saw (harbor freight version is killer with half moon metal wood blade)
File for smoothing out the plastic
Ummmm Beer????
Stock factory whale tail
Now lets get started
use the factory line that was created from the mold when they made the fender
Here you can faintly see the factory line
The plastic slag left behind from the saw, no get your file out
Purdy
Done!!! This is the version 1 creation... Just wait it gets more intense!
Now for version 2 not for the noobie! So pay attention and take your time!
First removing the factory plate mount
Now it's time to remove the section of the fendor where the lisense plate light goes. Pull on the wires behind this peice as the light is held in with a rubber socket
Again use the factory mold line to get everything dialed in perfectly
Finally removed the lower section
TAKE YOUR TIME NOW IF YOU FFFFFFFFFFF UP IT IS ON YOU!!! <---DISCLAIMER!!!
NOW SLOWLY Take little pieces out enabling you to open up this area of the fender. You can use the lines where the curves meet each other.
Getting closer to flushing this section out
TADA!!! We have a winner!!! No paying 100+ bucks for a fender delete kit
Hope you guys enjoy this!