The Honda PCX / Forza / ADV150 / SH Forums

Hi
My 2019 Forza 300 has been recovered following theft.
The thieves have taken the ECU so it is immobilised.
The garage told me I can get it running with a replacement ECU.
I see that the ECU has two connectors.
One is for the plug from the wiring loom but I don't know what plugs into the second connector.
I can't find any wiring diagrams or photos of the installation and can't work out what if anything goes into the other connector.
Can you help either by providing a wiring diagram or photos of your installation so I can see what plugs into the ECU.
Or if you can tell me what else I need to get to restore the missing bits.
I am assuming something goes into the ECU but of course it could be a diagnostic socket or something like that.
I know that it is quite fiddly to get the side panel off. The thieves just pulled mine off, breaking most of the fixings.
Any help is appreciated.
Thanks
Mark

Is the other connector a 4 wire/pin connector?

I just checked, should have looked before.
Both connectors are the same.
Male with 33 pins.
Pattern is 3 rows of 11 pins.
Ta
Mark

So it looks like I made an incorrect assessment.
It now looks like it was the Smart Control unit that was taken.
This explains why there is only the one connector!!!

Mark, I am in the same boat, I have replaced Smart Unit with a new one that came with a smart Fob. Bike now lights up, but it wont start...How did you overcome the problem

@adisMatrix your will need to have the new SCu paired with your ECU and then its ready to go. where are you located ? PM me i can help