The Honda PCX / Forza / ADV150 / SH Forums

Greetings!

I'm planning to buy some tools for a clutch/drive face bearing job on a PCX150, was also considering getting a valve adjustment tool, I see there are quite a few options.

1. Can someone please advise on the size of the locking nut and square adjuster?
2. What is the size of the holes in the drive pulley face (for the special tool pins)?

Many thanks.

Can nobody assist with these questions, many have replaced the belt and set the valve clearances?

Here is a link for an inexpensive home made clutch/variator tool............https://www.youtube.com/watch?v=YIVAimvORFI
Sorry.........can't help with valve adjustment but if you google 2012/2013 PCX valve adjustment .......you should get many hits.

You need a tool like this.