The Honda PCX / Honda Forza / SH Forums

Ignition switch wiring
Page 1 of 1

Author:  Stainless [ Wed Aug 30, 2017 4:03 pm ]
Post subject:  Ignition switch wiring

My Forza 125 was stolen recently, luckily the police recovered it whilst it was being used to steal another scooter. The offside upper front panel has been ripped off and the ignition switch wiring removed and twisted together, hot wiring it. When I collected it the battery was flat. I disconnected the wiring and managed to recharge the battery, I will probably have to replace the ignition switch as well as the panel. There are four wires, 2 red/blacks, 1 white/black and 1 red/green. I can't find out how these are connected by the ignition switch, I have a Haynes scooter manual which shows switch connections on the wiring diagrams but it doesn't cover the Forza. Can anyone help with this question.

Author:  you you [ Wed Aug 30, 2017 4:36 pm ]
Post subject:  Re: Ignition switch wiring

Sounds like you are from the UK but if you could put down your location it would help. There could be someone local to help you.

Author:  Stainless [ Wed Aug 30, 2017 5:07 pm ]
Post subject:  Re: Ignition switch wiring

I am in the UK, in the London area. I looked up the police pound website where they took my scooter, it said on there that 45 scooters/small bikes a day are being stolen in London. I wish I'd known that before my scooter was stolen.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group