The Honda PCX / Forza / ADV150 / SH Forums

Mel46 wrote:I think there are quite a few of us who have ordered from them. I don't recall ever reading anything bad about them, assuming you mean these guys.

https://www.bikerzbits.com/

Thank you Im going to convert my pcx to asian or european verision without bunny ears tail light.

First double check the circuit. By testing first unplug temp sensor, short the temp sensor wiring harness. . If fan goes on then circuit ok. if doesnt back circuit and relay and temp sensor and fuse.

Has anyone ordered parts from Biker Bits. Im curious and were you billed and Duty or Tax Fees.

i would torque it at 36 foot lbs. That should be good.

Look what I found. European headlamp 130.00

i replaced the clutch bearing no press needed. parts available from Babbets online cost around 25.00 bucks,

you you wrote:

pcx888 wrote:Has anyone have problems installing braided brake lines. Did you guys use existing OEM existing brackets,

I always try to use them as far as possible. Just takes a bit of ingenuity. Main issue is that they are thinner...

do you have any pictures of your installation.

Has anyone have problems installing braided brake lines. Did you guys use existing OEM existing brackets,

Honda automotive coolant and Motorcycle stuff same fluid. Just different containers.

thats why I switch to lipo battery. Never failed me yet. If it was a month then any “battery” will be marginal at that point. My other scooter is a carburetor scooter and that had no problems with the battery. So i guess the new fuel injected scooters have some system that uses electricity huh? Gen...

Does anyone know where to get front Braided lines for my 2011 PCX. I want to get local on in USA if possible.

I have a Kitaco gauge set.

maddiedog is Kitaco kit worth it.

i have had the Kitaco gauges now for over a year now and I love it.

I found the parts needed but too expensive to retrofit. 100.00 for headlamp assembly. Another 60.00 for the black bottom panel below the center console to cover rabbet ears cutout. and 150.00 to replace rear fender and rear turn signal assembly.

theres a ebay headlamp replacement. I asked the seller and he states new assembly uses h1 bulbs inside.

mem turbo where are you located at.

Every ride, or every other. Low oil will quickly & permanently damage an engine. Seriously low oil will kill it. New scooter engines are well over $1,000..... The wealthy can afford to be lazy about that 30 second procedure -- I can't. Fish I just rebuilt a complete 2013 pcx 150. Had to change ...

im planning to pull engine out. and rebuild head with valve job and valve seals. I will also change head gasket and piston rings. and piston too. Easy job for me.

yea, My bike always has half of 800ml that i put in at every oil change. But it runs fast and like a champ. Im planning to change oil every other month.