The Honda PCX / Forza / ADV150 / SH Forums

Will those rollers fit a 2014 300 forza ?? Thx

Thanks ..good advice for many....However I never in my life used any locktite. I have been doing this work for many years and never ever seen any fastener come apart or loosen once torqued properly. I find that thread locking chemicals only complicate removal in subsequent repairs and primarily used...

Start to finish on replacing clutch pads on Forza model using homemade tools . Overview of what the job entails and procedures I used . Afterwards the scooter ran satin smooth on start off and through out all speeds , turns , curves etc. Great improvement.FYI
https://youtu.be/JLL0Cg1YTRw

Start to finish on replacing clutch pads on Forza model using homemade tools . Overview of what the job entails and procedures I used . Afterwards the scooter ran satin smooth on start off and through out all speeds , turns , curves etc. Great improvement.FYI
https://youtu.be/JLL0Cg1YTRw

Hello Dave, have you ever replaced the clutch bearings in the 100k miles?

https://u.pcloud.link/publink/show?code ... fgs7U1yjXX
Withlacahoochee River and ride.

Thanks ..My next battery.

Looking for a good battery ..upsize from original ? Anyone have a good recommendation Lithium ION a possibility ? Thanks

Has the Forza 350 made it to the US yet.? Anyone even seen one in the states?

New switch.. You can use a dual toggle switch.. (3 position center pos. off)

I do not have ABS.. My slide pins are on the bottom of the pad..No grease on them as they are exposed to outside environment. These are also on front wheel. My brakes are not dragging just making a buzzing sound whenever I applied braking force. Could be something with these pads perhaps the design ...

I bought the sintered EBC . Had one groove down the middle separating the two halves The Honda brand was 47.00. and had 4 grooves.. I cleaned sanded them and even applied synthetic adhesive on the pad backing. Not grease.. In addition, I do not grease my slide pins but polished them smooth nice and ...

I installed EBC brake pads serrated type for my 2014 Honda Forza.. They performed nicely however after about 6 months of wear (minor) they were making a buzzing noise everytime I applied them . I reinstalled the originals back on and once again quiet and smooth.. Noisless. Maybe there is a reason to...

I had the palm rest some years ago too. Wasnt a good fit for me either. Looking for something a little bit better. Internet shows quite a few designs however thought I would inquire on here for first hand experience.

Do you know of any thats electronic . ?? Appreciate ingo. thx

I would not use a locking device without an instant disengagement feature , and then I would only use it on long sustained highway runs.I think its a nice option to have available.

I would like to install a throttle lock device for long rides as my hands cramp over some time. Anyone experience cramping and have a solution . I am thinking a cruise control device would help. Any ideas appreciated

Has this problem been resolved yet ? It seems like forward stopping inertia triggers the light. Check for loose wiring connector , dirty oil, or defective switch.

These bikes are assembled in Italy and Thailand. I believe they are the same belt but the part number varies as to the country of manufacture.