The Honda PCX / Forza / ADV150 / SH Forums

It takes 100 miles or more for the belt to bed in to match the new variator and drive face angles. So don't expect the best from the new setup on day one. Unless of course day one is a big day. :P And some subliminal messaging: http://cdnl.monsterscooterparts.com/media/catalog/category/451.jpg than...

well i installed the NYC kit yesterday, not thrilled about the new outer drive face not having the 2 holes like the stock unit for torquing the nut, took it out for a test run only about 5 miles, from a standing start, acceleration is very linear, top speed with the old worn tire and stock setup top...

i went to the webpage mel suggested to order the parts, i left them an email 2 days ago to see if everything is in stock, they never got back to me, anywhere else to try

chet

thanks for the replies. one thing i am skeptical is the front half of the variator with the fins does not have pin holes for the holding tool to loosen and tighten the nut on the engine shaft like the stock one.

Chet

i put new michelin city tires on my 2013 PCX, i notice the bike rolls real easy as compared to the stock tires i replaced at 3800 miles, as soon as i took it for a ride i noticed i lost acceleration, i can see that since the tires were a smaller dia, question have is, i want to make a change in the ...

any comments on this new scoot, 2017 Yamaha X-Max 300, anyone hear what the going price is going to be.

Chet

I am about ready to order a set of City Grips for my 2013 PCX, question i have is there are a few differnt types, not sure exactly what i need, some are r, s and maybe another letter, what do i need, and who has about the best prices at the moment

Chet

I got my PCX toward the end of the summer last year. It has 11,000+ miles on it. For about nine months, I used it much the way you do, once or twice a week on 55+ mph roads. When I went to assess the driven pulley bearing, i observed that the faces on the drive pulley had become pretty well grooved...

I have a 2013 PCX 150, there are times i make a 15-18 mile run on the interstates and thats is flat out bouncing off the rev limiter, maybe twice a week, for sure once, i keep it serviced ect, bike has 7500 miles on it now, will this kind of riding hurt it's engine life, would this be considered ha...

I have a 2013 PCX 150, there are times i make a 15-18 mile run on the interstates and thats is flat out bouncing off the rev limiter, maybe twice a week, for sure once, i keep it serviced ect, bike has 7500 miles on it now, will this kind of riding hurt it's engine life, would this be considered har...

i would like to charge my cell phone when i am riding, if i wire it direct to the battery imight forget to take it off may drain the battery, any other way to wire it so when i shut off the key the charging shuts off too. do i have to get into a relay for this

Chet

so a member says hitting the rev limiter, so that i find out is correct, SO this would mean being the tires are the same dia, and they are, it would be somewhere in the clutch not going all the in for the most speed or the belt not getting near the top or belt wear. where is the best place to start ...

purchased my PCX last summer ran great, i take it out last month, running good then i get out on the highway and i notice it seems to have a miss when i am wide open, if i back off about 1/8 throttle it seems to smooth-en out, last year the bike would hit just a tad over 70, this year 66 is tops. st...

i am curious if my 2013 would handle a cigarette lighter plug connected to the battery and charge my cell phone while riding

Chet

i have my 2013 PCX for about 3 weeks now, put almost 400miles on it, had 820 when i bought it, i noticed mainly on some hills the smell of the belt burning or slipping, is this common, if not where do i start looking into solving this issue, no problems on level roads,

Chet

i picked up the 2013 PCX 150 with 800 miles on it last week. i am curious with such a small oil reservoir and since the engine is under a more than normal load at times, does anyone change their oil sooner, i am thinking every 1000 miles or when ever it looks dark

Chet

I am new at the PCX only one week, one thing i noticed today, when the bike is idleing at a stop light or when i start it up at home, is that when i apply the rear brake it idles smoother. i let the brake go it changes the idle, i apply the rear brake the idle smooths out. puzzled

Chet

I might want to add to my above post, when i purchased the bike last week, it came with a grab bar and back rest, http://www.ebay.com/itm/Honda-PCX125-150-Bar-Backrest-Handle-Rear-Grab-Handle-Rack-REST-2010-2013-/161752864143?hash=item25a938d58f&vxp=mtr, this is the one on ebay my bike has, ques...

i have a 2013 PCX, i noticed the turn signal assembly is in 2 pcs, but the parts show it as one pc, it is separating at the seam between the hard plastic and rubber i tried to push it back in place but wont stay, i tried taking it apart but cant seem to see what holds the 2 sections together, any su...

i want to install a milk crate on my PCX, is this the correct PN to mount a milk crate to. Honda Plate 08L70-KZY-910
did i miss any other adapters that will work better for a milk crate install.

Chet